Crane Reinforcement Specifications
For Compartment Top Mounted Crane
3,500 LB. CAPACITY @ 3'-0"
(10,000 FT-LB MOMENT RATING - OUTRIGGERS RECOMMENDED)
For 60" CA dual rear wheel chassis and larger GVWR trucks |
| |
| 1. |
3" x 6" x 3/16" Structural Tubing Rear Crossmember , full width of
body. |
| |
| 2. |
3" x 3" x 3/16" Structural Tubing Intermediate Crossmembers , full width of
body, in front and rear of wheelwell. |
| |
| 3. |
7 ga. 6" High Formed Front Crossmember. |
| |
| 4. |
3" x 3" x 10 ga. Formed Channel , Full Length Longitudinal Stiffeners (3 ea.) |
| |
| 5. |
3/8" high strength Vertical plate extending from each crossmember in front
and rear of crane compartment and on back wall. |
| |
| 6. |
7 ga. Shelf extending between crossmembers with 1" lip front. |
| |
| 7. |
3" x 4" x 3/8" Structural angles between support columns at top of crane
compartment. |
| |
| 8. |
(2) 1/2" Mounting Plates , (1) at top inside and (1) at top outside of crane
compartment (not drilled). |
| |
| 9. |
10 ga. channels from bottom of full width rear crossmember to bottom of
compartment on each side of body to accommodate under body outrigger
mounting. |
| |
| 10. |
1/8" Treadplate Steel Floor. |
| |